Previous Thread
Next Thread
Print Thread
91 D44 intermediate shaft seal question. #1409946
03/27/13 10:19 PM
03/27/13 10:19 PM
Joined: Oct 2008
Posts: 151
Albion NY
H
Haibach Boys Offline OP
member
Haibach Boys  Offline OP
member
H

Joined: Oct 2008
Posts: 151
Albion NY
im rebuilding the front axle on my w150, ball joints, new outer axles, wheel bearings, blah blah, now i wanta change the intermediate shaft seal in the housing, its on the drivers side of the Cad box. how the heck do i get it out and install it??? if the pic loads the one labeled "Seal"

7643630-cad_mechanism.jpg (131 downloads)
Re: 91 D44 intermediate shaft seal question. [Re: Haibach Boys] #1409947
03/27/13 11:49 PM
03/27/13 11:49 PM
Joined: Aug 2005
Posts: 11,543
chicagoland,usa
B
buildanother Offline
I Live Here
buildanother  Offline
I Live Here
B

Joined: Aug 2005
Posts: 11,543
chicagoland,usa
I'm sure the dealers had a special tool for that, but I made my own out of a 2 foot 3/8" threaded rod and some combination of washers and old bearing races or something. It was a pain, and a while ago.

Re: 91 D44 intermediate shaft seal question. [Re: Haibach Boys] #1409948
03/28/13 09:42 PM
03/28/13 09:42 PM
Joined: Apr 2004
Posts: 684
Maine
J
jerseybud Offline
mopar
jerseybud  Offline
mopar
J

Joined: Apr 2004
Posts: 684
Maine
Pull the cad hosuing and fork, then the collar, knock the seal out after the axle shaft is out, pull old seal out and put new seal in on driving mandrel and use threaded rod to pull in. Use only a oem mopar or timken seal (or in pick skf). Do not use a National seal- they got the dimensions wrong

Can buy this, but he sells just the mandrels also and get the threaded rod/nuts/washers at the hardware store. Mandrels keep it straight. Hard to navigate his site now since he screwed it up...
http://www.quad4x4.com/cgi-bin/commerce.cgi?preadd=acton&key=884620

Limited pics of how I did it here, 3/4 way down page
http://ramchargercentral.com/mopar-trucks/1999-w250-project/

Last edited by jerseybud; 03/28/13 09:44 PM.






Powered by UBB.threads™ PHP Forum Software 7.7.1