|
Panhard Bar
#1012969
06/13/11 11:01 PM
06/13/11 11:01 PM
|
Joined: Jun 2008
Posts: 251 Lithonia, Ga
36PLYM
OP
enthusiast
|
OP
enthusiast
Joined: Jun 2008
Posts: 251
Lithonia, Ga
|
Anybody have info on a bracket to attach panhard to 8 3/4 center section? Maybe at the snubber location?
36 Plymouth Coupe 318 w/360 heads 518 trans 8 3/4 rear Ga. Tech BCE'78
|
|
|
Re: Panhard Bar
[Re: poorboy]
#1012971
06/14/11 07:41 AM
06/14/11 07:41 AM
|
Joined: Jun 2008
Posts: 251 Lithonia, Ga
36PLYM
OP
enthusiast
|
OP
enthusiast
Joined: Jun 2008
Posts: 251
Lithonia, Ga
|
That was my first choice but the bolts are to short even for 3/16 plate. Are those bolts pressed into the carrier? Thanks.
36 Plymouth Coupe 318 w/360 heads 518 trans 8 3/4 rear Ga. Tech BCE'78
|
|
|
Re: Panhard Bar
[Re: 36PLYM]
#1012973
07/07/11 09:38 PM
07/07/11 09:38 PM
|
Joined: Jan 2003
Posts: 4,279 Florida
blewbyu
master
|
master
Joined: Jan 2003
Posts: 4,279
Florida
|
Quote:
Anybody have info on a bracket to attach panhard to 8 3/4 center section? Maybe at the snubber location?
Here You Go
|
|
|
Re: Panhard Bar
[Re: blewbyu]
#1012974
07/07/11 09:38 PM
07/07/11 09:38 PM
|
Joined: Jan 2003
Posts: 4,279 Florida
blewbyu
master
|
master
Joined: Jan 2003
Posts: 4,279
Florida
|
Quote:
Quote:
Anybody have info on a bracket to attach panhard to 8 3/4 center section? Maybe at the snubber location?
Here You Go 2
|
|
|
Re: Panhard Bar
[Re: 36PLYM]
#1012975
07/07/11 10:25 PM
07/07/11 10:25 PM
|
Joined: Sep 2007
Posts: 14,889 up yours
Supercuda
About to go away
|
About to go away
Joined: Sep 2007
Posts: 14,889
up yours
|
One of the reasons a panhard rod isn't optimal is that it tends to move the housing side to side as it goes up and down. To lessen the effect you want a panhard rod to be as long as possible. I would attach it to the axle flange on the axle end if at all possible.
Or, if you want to eliminate the problem altogether, use a watts linkage.
They say there are no such thing as a stupid question. They say there is always the exception that proves the rule. Don't be the exception.
|
|
|
|
|
|