I have been up with this subject before, but want to be sure I am doing right.
I have a completely stock 1976 360 block in very good condition. The heads to be used are casting 3418915 2,02 valve. The cc are 64,2
I want to give the engine a new set of pistons and a performance cam to gain more power.

I am kean to buy a complete engine rebuilt kit.

http://cgi.ebay.com/ebaymotors/Dodge-Ply...sQ5fAccessories

But has been told I can get more performance without compromise drive ability.

Have in this forum been advised to install
Keith black 190 pistons and Comp cam extreme energy XE284H cam

Can it be confirmed this set up will cause no trouble on pump gas, also I don't want to ruin idle.
Can I really run pump gas on a compression rate above 10,5:1 ?

Or should I more likely go for KB107 pistons and XE268H cam.


All competent advice and experience welcome
Thanks