Just received the 8MM valves this afternoon. Here are the initial results, 1.92"/1.625" MP stainless valves, straight 45*, these are a set of Dodge Truck Magnum iron heads:

LIFT----AS CAST
---------IN/EX
.100"--67.3/N/A
.200"--131.3/97.3
.300"--185.6/132.5
.400"--212.5/144.9
.450"--213.9/146.3
.500"--212.2/146.3
.550"--212.5/146.3
.600"--213.9/146.6
.650"--214.2/147.3
.700"--215.3/147.3

Did some whittling on them:

















LIFT------IN/EX
.100"--67.3/N/A
.200"--132.8/115.6
.300"--196.0/156.6
.400"--225.0/172.2
.450"--238.1/174.3
.500"--250.5/176.6
.550"--257.1/178.0
.600"--259.1/180.8
.650"--259.1/180.8
.700"--259.8/180.8

The intake port has'nt had the chamber deshrouded on the sides, so the low lift will only get better. Overall I'm happy with it for a 1.92" valve and that God awful rocker boss taking up 1/2 the intake runner.

The exhaust I'm not happy with at all. It's either in the short turn, or just the still small runner/exit, So first order of business is to open it up a little more and see where that get's me. I will not quit until I see over 200 cfm.