Quote:

And this a metro "Authentic Mopar reproduction" part Looks like the fit is determined per the careful installation. Only the two upper screw holes were drilled I had to elongate one a little. Then I use a scribe to mark the holes to be drilled while it is carefully held in place.....


That looks pretty good. How much massaging did you have to do to get it on? Was there any point where the trim seemed close to the point of buckling as you formed it into place?
With all the controversy about these parts, I would be happy for mine to look like that.
Craig


2014 Ram 1500 Laramie, 73 Cuda
Previous mopars: 62 Valiant, 65 Fury III, 68 Fury III, 72 Satellite, 74 Satellite, 89 Acclaim, 98 Caravan, 2003 Durango
Only previous Non-Mopar: Schwinn Tornado