Question to all -- I've just reinstalled one of my spindles (no rotors etc) and the one spindle I installed is hard to turn/move freely. Could over-tightening the two nuts (uca, lbj) for the spindle cause this? 100 top, 80 lower. I have yet tried to the other side. I'm thinking that maybeeeee as its tightened against the extended height rubber snubber which i use against/under the UCA, that maybe that has caused this situation.

No motor yet as the kframe was just recently reinstalled after the engine bay was redone.


Mopar Mitch "Road racers and autocrossers go in deeper and come out harder!"... and rain never stops us from having fun with our cars... in fact, it makes us better drivers! Check out MOPAR ACTION MAGAZINE, August 2006 issue for feature article and specs on my autocross T/A!