For a low deck stroker running 6.700" rods and pistons with a 1.320 CH (Diamond flat tops) - what should the crank be ground to for final stroke?

I've seen both 3.91 and 3.90 used a fair bit, but if I'm doing the math right (and there's a good chance I'm not)

With 3.90 stroke:

1/2 stroke: 1.95"
plus rod: 6.70"
plus piston: 1.32"

Gives 9.97" against a 9.98" deck height, so all things being equal, the pistons will be .010 down in the hole

With 3.91 it goes to .005 down in the hole and 3.92 should be zero deck

So without going into major block work/measurement, which is the best choice to keep both compression up but also a margin of safety for stretch/expansion of the reciprocating assembly?

Heads will be open chamber - worked 346s

Thanks in advance



gives